Table of Contents
Advertisement
11. Line up the holes in the underside of the drive with
those in the base of the drive bay.
12. Insert the four drive securing screws, and tighten
them until they are finger tight.
13. Gently tighten the four screws.
14. Turn the drive bay over and replace it in the system
unit.
15. Slide the bay forwards until the two holes in the bay
line up with those in the hard drive assembly and the
system unit brace.
16. Replace the two screws that secure the drive bay.
SECURING SCREWS
A C T
C O M P
43
Advertisement
Table of Contents
