Table of Contents
Advertisement
Local
This should be selected if the computer is to boot from an
internal hard disk or floppy drive.
It should be noted that when one of the remote boot schemes
described below is enabled it is not possible to boot the
computer from a local device. If you wish a XEN-LS II, that
normally boots remotely using the on-board Ethernet
interface, to boot from a local device, you must first use
SETUP to select Local in the boot device option group.
Note
This option should be selected if you want the computer to
boot remotely from a server using a network interface on
an expansion card.
Ethernet
If the computer is connected to an Ethernet network using
the on-board Ethernet interface, and it is to boot remotely
from a server using the RPL (Remote Program Load)
scheme, enable this option.
Other
This option is provided for possible future implementation of
other remote boot methods for the on-board Ethernet
interface. It is currently greyed out.
Memory
The memory text box displays a count of the amount of
memory installed in the system. The contents of the text
box cannot be edited and is displayed for information only.
Separate counts of total and extended memory are
displayed.
Power-on sound
When this option is enabled the XEN-LS II audio
subsystem provides an audible indication that the system
has been switched on.
8
Advertisement
Table of Contents
