Table of Contents
Advertisement
There are only two exceptions to this. In the two situations
given below, although the computer will operate if the
SIMMs are swapped it is preferable if the SIMMS are
installed as described.
*
If you are installing a 4Mbyte SIMM it should always
go in MM1, unless there is a 4 or 32Mbyte SIMM in
the socket already.
*
If you are installing a 32Mbyte SIMM it should
always go in MM1 unless there is a 32Mbyte SIMM
in the socket already.
If in either of the cases above you install a 4 or 32 Mbyte in
MM2 when you power the system up you will be prompted
to swap the SIMMs.
Installation
In order to install a memory upgrade you must:
1. Power the system down.
2. Take suitable anti-static precautions and remove the
system unit cover.
If you are unfamiliar with Apricot's recommended
anti-static precautions and/or the process of
removing the system unit cover refer to your
Owner's Handbook .
27
Advertisement
Table of Contents
