Adaptation For Another Gas Type - Bartscher 5FL EBO-1 Instruction Manual

Connection with a metal hose

Gas connection can be made with an appropriate hose complying with national
standards, whereas the easily accessible certified gas shut-off valve must be installed
between the gas installation and the device, to ensure that if necessary the gas supply
could be quickly shut off.

The maximum hose length is 2 metres.

Make sure that the hose does not touch hot elements of the oven. The metal hose
cannot be bent or stretched. It is allowed to use only such hose ties which comply with
installation regulations.
Connection to a gas bottle
If the device is connected to a gas bottle, it should be equipped with a pressure reducer,
and connections installed in accordance with local regulations. When connecting to a
gas bottle be sure to remember:

the hose to the gas connection cannot exceed a length of 1-1.2 m;

the pressure reduction connection must be directed to the outside;

the hose must not come into contact with hot surfaces of the device (the rear or
top of the device, oven, etc.);

the gas bottle must not touch the side bordering with the oven.

After cooking/baking, always close the gas bottle valve.
CAUTION!
After installation, check that the connections are tightly fitted. Do not use a
flame to inspect the gas installation seals, but use a soap solution instead.

5.1.5 Adaptation for another gas type


The unis has been designed and certified for use with the gas type listed on the
rating plate (natural gas).

The device can be adapted to other gas types as necessary using special jets and
settings. The device comes equipped with jets for liquid gas adaptation.

Disconnect the device from its electricity source and close off the gas supply if you
choose to adapt the unit.
- 48 -