Port Monitor - Hirschmann Greyhound GRS1020 Reference Manual

6.4.3

Port Monitor

[ Diagnostics > Ports > Port Monitor ]
The Port Monitor
Monitor function detects that the parameters are being exceeded, then the device performs an
action.
To apply the
Global

Enable the

Activate for each port those parameters that you want the

Link flap,

Specify the threshold values for the parameters for each port.

Link speed/Duplex mode detection

Activate the allowed combinations of speed and duplex mode for each port.

Global

Specify for each port an action that the device carries out if the

that the parameters have been exceeded.
Auto-disable

Mark the

disable
The dialog contains the following tabs:
[Global]

[Auto-disable]

[ Link flap]

[CRC/Fragments]

[Overload detection]

[Link speed/Duplex mode detection]

[Global]
In this tab, you enable the
function is monitoring. Also specify the action that the device carries out if the
detects that the parameters have been exceeded.
Operation
Operation
Enables/disables the
Possible values:
On

The Port Monitor
Off

The Port Monitor
RM GUI GRS
Release 8.0 09/2019
function monitors the adherence to the specified parameters on the ports. If the
Port Monitor function, proceed as follows:
tab
Operation function in the
CRC/Fragments and Overload detection
tab
tab
Auto-disable checkbox for the monitored parameters if you have specified the
action at least once.
Port Monitor
Port Monitor
function is enabled.
(default setting)
function is disabled.
Port Monitor frame.
tabs
tab
function and specify the parameters that the
function globally.
Diagnostics
[ Diagnostics > Ports > Port Monitor ]
Port Monitor function to monitor.
Port Monitor function detects
Port Monitor
Port Monitor
Port
auto-
function
273