Lldp; Lldp Configuration - Hirschmann Greyhound GRS1020 Reference Manual

Type
Specifies which data packets the device copies to the destination port.
Possible values:
none

No data packets.
tx

Data packets that the source port transmits.
rx

Data packets that the source port receives.
txrx

Data packets that the source port transmits and receives.
Note: With the
destination ports needs at least a bandwidth that corresponds to the sum of the send and receive
channel of the source ports. For example, for similar ports the destination port is at 100 % capacity
when the send and receive channel of a source port are at 50 % capacity respectively.
On the destination port, the device adds a VLAN tag to the data packets that the source port
transmits. The destination port transmits unmodified the data packets that the source port receives.
Buttons
You find the description of the standard buttons in section
Reset config
Resets the settings in the dialog to the default settings and transfers the changes to the volatile
memory of the device (RAM).
6.5

LLDP

[ Diagnostics > LLDP ]
The device lets you gather information about neighboring devices. For this, the device uses the Link
Layer Discovery Protocol (LLDP). This information enables a network management station to map
the structure of your network.
This menu lets you configure the topology discovery and to display the information received in table
form.
The menu contains the following dialogs:

LLDP Configuration


LLDP Topology Discovery

RM GUI GRS
Release 8.0 09/2019
(default setting)
txrx setting the device copies transmitted and received data packets. The
[ Diagnostics > LLDP ]
"Buttons" on page 13.
Diagnostics
291