Gigabit Combo Port; 10/100/1000 Mbit/S Twisted Pair Port - Hirschmann MACH1040 User Manual

1.4

Gigabit combo port

The MACH1040 device provides 16 combo ports for transmission speeds of
up to 1000 Mbit/s.
You have the option of alternatively connecting a twisted pair cable via a
RJ45 socket or an optical fiber via a SFP transceiver to a combo port.
(see table 2 on page 20
By inserting a SFP transceiver, you deactivate automatically the
corresponding twisted pair interface.
Use only Hirschmann SFP transceivers which are suitable for usage with the
device.
See "Accessories" on page 57.
You find information on the pin assignments for making patch cables here:
"Pin assignments" on page 25
1.4.1

10/100/1000 Mbit/s twisted pair port

This port is an RJ45 socket.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
The MAR1042 and MAR1142 devices also allow:
IEEE 802.3af (Power over Ethernet on data lines).
This port supports:
 Autonegotiation

Autopolarity
 Autocrossing (if autonegotiation is activated)

1000 Mbit/s full duplex
 100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode

10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
 Also for MAR1042 and MAR1142:
Power over Ethernet (PoE) at the first 4 ports of the device
The PoE power is supplied via the wire pairs transmitting the signal
(phantom voltage).
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
24
to table 5 on page 22)
Installation MACH1040
Release 05 03/2021