Table of Contents
Advertisement
TONiC FS T40x1 readhead installation drawing
(RESM 'A' section ring shown)
2 off mounting holes M2.5 through,
counterbored Ø3 × 2.75 deep from
alternative mounting face
R>20 Dynamic bend radius
R>10 Static bend radius
4.6
*
Extent of mounting faces.
†
Minimum thread engagement 5 mm (7.5 including counterbore). Tightening torque 0.25 to 0.4 Nm.
NOTE: External magnetic fields greater than 6 mT, in the vicinity of the readhead, may cause false activation of the limit and reference sensors.
TONiC RESM20 Functional Safety installation guide and safety manual
Optical centreline
(incremental and reference mark)
18
31
16
3
22
29
6 min
35
23
11.5
'A' section – Offset 1.75 ±0.5
'B' section – Offset 3.25 ±0.5
7.5
3
Set-up LED
CAL/AGC LED
2 off mounting holes 2.5 through, counterbored Ø3 × 2.3 deep both sides
(Pitch tol. ±1°)
0.6
Rideheight 2.1 ±0.15
Original instructions
(Yaw tol. ±0.4°)
(Roll tol. ±0.5°)
0.25
0.08
13.5
Alternative
mounting
Recommended
mounting faces
†
Forward direction of ring
(increasing count)
Dimensions and tolerances in mm
8.75 *
*
11
4.25
face
4.15
10
6
Advertisement
Table of Contents
