Usb Device Panel/Wall Mounting; Usb Device Leds; Usb Cable Strain Relief - National Instruments M Series User Manual

Chapter 1 Getting Started

USB Device Panel/Wall Mounting

x x x
(USB-622 /625 /628 Devices)
(part number 780214-01, not included in your USB-62xx kit) is an accessory you can use to
mount the USB-62xx family of products to a panel or wall.

USB Device LEDs

x x x
(USB-622 /625 /628 Devices)
and LED Information, for information about the M Series USB device LEDs.

USB Cable Strain Relief

x x x
(USB-622 /625 /628 Screw Terminal and USB-622
Devices) Use the supplied strain relief hardware to provide strain relief for your USB cable.
Adhere the cable tie mount to the rear panel of the USB-62xx Screw Terminal or USB-62xx Mass
Termination device, as shown in Figure 1-6. Thread a zip tie through the cable tie mount and
tighten around the USB cable.
Figure 1-6. USB Cable Strain Relief on USB-62xx Screw Terminal and
USB-62xx Mass Termination Devices
x x
(USB-622 /625 BNC Devices)
end cap to provide strain relief for your USB cable as shown in Figure 1-7. The strain relief holes
can also be used as cable management for signal wires to/from the screw terminals and BNC
connectors.
1-8 | ni.com
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The Externally Powered USB M Series Panel Mounting Kit
LED Patterns
Refer to the section of Chapter 3,
x x
/625 /628
Thread a zip tie through two of the strain relief holes on the
Connector
x
Mass Termination