Kirsch Cellular Shade Collection Installation Instructions Manual page 21

Attach the valance to the valance clips, as shown.
■ ■
nsert the top of the valance into the top of the
➤ ■
valance clip.
Rotate the valance down to snap it into place
➤ ■
onto the headrail.
TIP: Tap the valance at each clip to assure that the valance is securely attached to the valance clips and the clips are securely
attached to the headrail.
Traditional Valance
Outside mounts and non-flush inside mounts only: Use the valance corner brackets to
■ ■
attach a return to each end of the valance.
Fit the tabs on the corner bracket into the notches on the valance and return.
➤ ■
Be sure the mitered corners are flush.
➤ ■
Headrail widths over 96" with two-piece valances: Lay the two pieces of the valance on a flat surface and connect them by
■ ■
placing a dovetail bracket at the seam.
INSTALLATION
INSTALLATION
Valance
Outside Mount
Dovetail
Bracket
20
Inside Mount
Front of
Valance
Notch
Valance
Return
(Cross-
Section)
Notch
Corner
Bracket