Table of Contents
Advertisement
Teldat SA
Chapter 4 Reset
If the configuration is incorrect or your device cannot be accessed, you may use the Reset button to reset the device
to the ex works standard settings.
All existing configuration data will be erased!
To do this, follow these steps:
(1) Keep the Reset button pressed for approximately 30 seconds.
(2) Look at the LEDs:
- While the Status LED is permanently lit, the device runs through the reset and boot sequence.
- As soon as the Status LED signals normal operation again (blinking), the reset is complete. Release the Re-
set button.
You can now configure your device again, as described in
Note
If you delete the boot configuration using GUI, all passwords will also be reset and the current boot
configuration deleted. Next time, the device will boot with the standard ex works settings.
APR222ac
Basic configuration
on page 6.
4 Reset
13
Advertisement
Table of Contents
Need help?
Do you have a question about the APR222ac and is the answer not in the manual?
Questions and answers