Power On And Power Off The Camera Unit; Power On The Camera Unit - Panasonic AW-UE4 Series Operating Instructions Manual

Power on and Power Off the Camera Unit

Power on the Camera Unit

When performing the operations using the wireless remote control.
1. Set all the power switches of the units and devices connected in the system to ON.
The unit does not have a power switch. When power is supplied to it, the status indicator LED will
light up orange.
2. Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.
The unit's status indicator LED blinks green when a signal matched by the remote control ID has
been received, and it blinks orange when a signal that is not matched by the remote control ID has
been received.
3. Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The POWER ON mode is established, images are output, and control can be exercised.
The unit's status indicator LED now lights up green.
[Note]
 It takes about 30 seconds per unit for the initial settings operation to be completed. During this
period, the unit cannot be operated.
 The unit stores its STANDBY / POWER ON mode status in the memory.
 If the power supply is cut off while the operation is in POWER ON mode, the operation will transfer
to the POWER ON mode the next time power is supplied.
 When transferring to the STANDBY mode
- Status indicator LED: Orange
- The pan/tilt position is stored in the memory, and the pan/tilt unit is moved so that it points
backwards.
 When transferring to the POWER ON mode
- Status indicator LED: Green (after the initial setting operation is completed))
- The pan/tilt unit is moved to the position which was stored in the memory when the transition to
the STANDBY mode was made.
 POWER ON preset
- The pan/tilt unit is moved to the setting, which was established immediately prior to the transition
to the STANDBY mode, when the power has been turned on.
 If the power is turned off without transferring to the STANDBY mode, the pan/tilt unit position will
not be stored in the memory or reflected in the POWER ON preset. The previous POWER ON
preset will be applied.
4. If multiple units are going to be used, repeat steps 2 and 3 as required.
63