Table of Contents
Advertisement
When the unit is no longer going
to be used, do not leave it lying
around, but be absolutely sure to
dispose of it properly.
When installing, transferring or
disposing of the unit, be
absolutely sure to hold it by its
pedestal area.
Problems may result if the camera head is
held or rotated.
Do not attach a filter, hood,
extender or other parts to the
unit.
Install the external DC power
supply near the main power
outlet, and position it in such a
way that its power plug can be
plugged into and unplugged
from the outlet easily.
When connecting the external DC power
supply to a power outlet on the ceiling or on
any other surface where dust may collect,
wipe off the dust on the power plug at
periodic intervals as an anti-tracking
measure.
If there is a possibility of noise
interference
Either wire the cables so that the power
cable (ceiling light cord) of
AC 100 V (AC 220 V) or more, and the signal
cable are placed at least 1 meter (3.3 ft.)
apart.
Alternatively run each cable through its own
metal conduit. (The metal conduits must be
grounded.)
When connecting the cables,
ensure that the connector areas
will not be subject to any load.
Doing so may cause malfunctioning
Power switch
This unit does not have a power switch.
Before proceeding with maintenance, be
absolutely sure to disconnect the power plug
from the power outlet.
[Note]
Under factory default conditions, the unit
will be in Standby mode when power is
supplied for the first time. (Status display
lamp: Lit orange)
When the power supply is cut off while
the unit is in Standby mode, the unit will
be in Standby mode the next time power
is supplied. (Status display lamp: Lit
orange)
When the power supply is cut off while
the unit is in Power ON mode, the unit will
be in Power ON mode the next time
power is supplied. (Status display lamp:
Lit green)
Radio signal interference
If the unit is positioned near a TV or radio
transmitting antenna or a strong electrical
field or magnetic field (such as that
generated by a motor, transformer or power
lines), its images may be distorted and/ or
the images may be affected by noise.
Allowing the generated heat to
escape
This unit allows the heat generated inside to
escape from its surfaces.
Do not install the unit in a location where it
will be surrounded by walls or other surfaces
and where heat will be trapped.
In addition, the heat is dissipated to the
bottom panel which will warm up over time:
This is normal and not indicative of any
trouble.
11
Advertisement
Table of Contents
