Panasonic AW-UE4 Series Operating Instructions Manual page 26

EMC NOTICE FOR THE PURCHASER/USER OF THE
APPARATUS
1. Pre-requisite conditions to achieving compliance with the above standards
<1> Peripheral equipment to be connected to the apparatus and special connecting cables

The purchaser/user is urged to use only equipment which has been recommended by us
as peripheral equipment to be connected to the apparatus.

The purchaser/user is urged to use only the connecting cables described below.
<2> For the connecting cables, use shielded cables which suit the intended purpose of the
apparatus.

Video signal connecting cables
Use double shielded coaxial cables, which are designed for 75-ohm type high-frequency
applications, for SDI (Serial Digital Interface).
Coaxial cables, which are designed for 75-ohm type high-frequency applications, are
recommended for analog video signals.

Audio signal connecting cables
If your apparatus supports AES/EBU serial digital audio signals, use cables designed for
AES/EBU.
Use shielded cables, which provide quality performance for high-frequency transmission
applications, for analog audio signals.

Other connecting cables (IEEE1394, USB)
Use double shielded cables, which provide quality performance for high-frequency
applications, as connecting cables.

When connecting to the DVI signal terminal, use a cable with a ferrite core.

If your apparatus is supplied with ferrite core(s), they must be attached on cable(s)
following instructions in this manual.
2. Performance level
The performance level of the apparatus is equivalent to or better than the performance
level required by these standards.
However, the apparatus may be adversely affected by interference if it is being used in an
EMC environment, such as an area where strong electromagnetic fields are generated (by
the presence of signal transmission towers, cellular phones, etc.). In order to minimize the
adverse effects of the interference on the apparatus in cases like this, it is recommended
that the following steps be taken with the apparatus being affected and with its operating
environment:
1. Place the apparatus at a distance from the source of the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power outlet where the power is not shared by any other
appliances.
26