Power On And Power Off The Camera Unit; Power On The Camera Unit; Power Off The Camera Unit - Panasonic AW-UE4 Series Operating Instructions Manual

Power on and Power Off the Camera Unit

Power on the Camera Unit

When performing the operations using the wireless remote control.
1. Set all the power switches of the units and devices connected in the system to ON.
The unit does not have a power switch. When power is supplied to it, the status indicator LED will light up orange.
2. Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.
3. Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The POWER ON mode is established, images are output, and control can be exercised.
The unit's status indicator LED now lights up green.
[Note]
 It takes about 30 seconds per unit for the initial settings operation to be completed. During this period, the unit
cannot be operated.
 The unit stores its STANDBY / POWER ON mode status in the memory.
 If the power supply is cut off while the operation is in POWER ON mode, the operation will transfer to the POWER
ON mode the next time power is supplied.
 When transferring to the STANDBY mode
- Status indicator LED: Orange
 When transferring to the POWER ON mode
- Status indicator LED: Green (after the initial setting operation is completed)
- The pan/tilt position is moved to the position which was stored in the memory when the transition to the
STANDBY mode was made.

POWER ON preset
- The pan/tilt position return to the place just before entering STANDBY mode when returning from STANDBY
mode to POWER ON mode.
 If the power is turned off, the pan/tilt position returns to the initial state.
4. If multiple units are going to be used, repeat steps 2 and 3 as required.
The unit's status indicator LED blinks green when a signal matched by the remote control ID has been received,
and it blinks orange when a signal that is not matched by the remote control ID has been received.

Power off the Camera Unit

When performing the operations using the wireless remote control
1. Press one of the [CAM1] to [CAM4] buttons on the wireless remote control to select the unit.
2. Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The unit enters STANDBY mode.
3. The unit's status display lamp now lights up orange.
4. If a multiple number of units are used, repeat steps 1 and 2 as required.
5. Set all the power switches of the units and devices connected in the system to OFF.
22