Siruba 700KS Instruction Book page 25

(2) 依照桌板，調整下勾針Ａ的距離設定， 下
勾針會從第一針孔穿過 1.3mm 的位置。
( 圖 31)
(3) 當下勾針向右移至針中心時 ( 雙針以左針 )
針與勾針之間隙為 0~0.05mm。( 圖 31)
3. 上勾針與下勾針之關係
當上下勾針相交時，兩勾針盡量接近，但不
可磨擦或碰撞，其間隙 A 點為 0.5mm B 點
為 0.2mm。( 圖 32)
(2)Based on the table, adjust the distance
setting of the lower lopper A. The lower
looper will pass from the first needle hole
through the position of 1.3mm. (Fig.31)
(3)The clearance between the needle and the
looper is 0~0.05mm, when the lower looper
moves rightward to the center of the needle
(The left needle is main while using double
needles) (Fig.31)
3. Relation between the upper looper and the
lower looper
When the upper and the lower loopers
meet, they reach each other as close as
possible, but should not rub or hit each
other. The clearance of point A is 0.5mm
and the B point is 0.2mm. (Fig.32)
Introduction
圖 31 / Fig. 31
圖 32/ Fig. 32
P22