Siruba 700KS Instruction Book page 23

3. 輔助送布齒高度
輔助送具① ，其齒面比送布齒齒面低
0.1~0.3mm，可放鬆螺絲②來調整。
( 圖 27)
4. 主送布齒與針板之關係
當設定送料量為最大時，需確認主送齒與針
板狹縫留有 0.8mm 的距離。( 圖 28)
3. The height of the auxiliary feed teeth
The auxiliary feed dog ①, the side of teeth
is lower 0.1~0.3mm than the teeth side of
the feeder. Loosen the screw ②to adjust.
(Fig.27)
4. Relation between the main feeder and the
needle plate
When setting the feeding amount is the
largest, it is necessary to confirm the
distance between the main feeder and the
needle plate is 0.8mm. (Fig.28)
Introduction
圖 27 / Fig. 27
圖 28 / Fig. 28
P20