Audi A6 / A6- Avant / Audi A7 Sportback
Fuel
CAUTION!
Open the vehicle's fuel tank cap, ventilate the tank and then re-close the tank lock.
Catch any fuel running off in an appropriate container.
Install fuel line and metering pump wiring harness so that they are protected against stone impact. Un-
less specified otherwise, always fasten using cable ties.
Provide rub protection for fuel line and wiring harness in areas where there are sharp edges.
WARNING!
The fuel line and wiring harness are routed to the metering pump as shown in the wiring harness rout-
ing diagram.
1
3
2
1
1
1
2
Ident. No.: 1317500E_EN
67
1
1
68
1
69
Status: 19.03.2015
Pull fuel line 2 and wiring harness of metering
pump 1 into corrugated tube.
3 10 mm dia. clamp
Route fuel line and wiring harness of meter-
ing pump into corrugated tube 1 in the right-
hand wheel well to the line duct.
Route fuel line and wiring harness of meter-
ing pump into corrugated tube 1 through orig-
inal vehicle cable duct 2 to the underbody.
Connect-
ing heater
Installing
lines
Installing
lines
© Webasto Thermo & Comfort SE
27