Troubleshooting; Troubleshooting During Startup - Keysight Technologies E5080B Installation Manual

Keysight E5080B ENA Series RF Network Analyzers
Installation Guide

2 Troubleshooting

This chapter describes the troubleshooting during start up and the procedure
of the operating system (OS) recovery when the Windows OS has been
damaged.

Troubleshooting during Startup

When you encounter the problem during start up, see
recovery saves most of problems.
Table 2-1 Troubleshooting during startup
Symptom
Turning on the standby switch does not
start up the system.
The system starts up, but it automatically
shuts down immediately.
The system starts up, but it enters the
service mode (The instrument status bar
in the lower right part of the screen
displays SVC in red).
The measurement screen appears after
startup, but the power-on test is failed,
with Error Message 241 appearing
against a red background in the
instrument message/warning area in the
lower left part of the screen.
Solution
Confirm that the power cable is properly
plugged in.
Execute the system recovery.
21
Table 2-1. System