Table of Contents
Advertisement
3.2
Assembly
3.2.1
Mounting overflow
>3mm
<3mm
Multiplex Trio drain/overflow Visign MT9
Proceed as follows to the mounting of the overflow:
Push the rubber sleeve onto the pipe of the overflow unit.
The lower edge must be flush with the edge of the overflow pipe.
Fit the profile seal in the overflow unit.
If the wall thickness is smaller than 3 mm (in the case of steel bath-
tubs), insert an addition seal between profile seal and bathtub.
Join flange cover and supply flange.
Place the sealing element on the supply flange.
Fit the supply flange into the overflow unit.
Handling
12 from 22
Advertisement
Table of Contents
