Figure 58. Hardware Wizard: Interface Dialog Box - Princeton Instruments PhotonMAX System Manual

72
At this point, you will need to exit WinView and run the RSConfig.exe program, which
creates a file called PVCAM.INI. This file contains information required to identify the
interface/camera and is referenced by the Hardware Wizard when you are setting up
WinView/32 with the PhotonMAX for the first time:
1. If you have not already done so, close WinView/32 or WinSpec/32.
2. Make sure the PhotonMAX is connected to the host computer and that it is powered
3. Run RSConfig from the Windows|Start|Programs|Roper Scientific menu or
4. When the RSConfig dialog box (Figure 59) appears, you can change the camera
5. You should now be able to open WinView and, from Setup|Hardware..., run
6. When the PVCAM dialog box (Figure 60) is displayed, click in the Yes radio
PhotonMAX System Manual

Figure 58. Hardware Wizard: Interface dialog box

on.
from the directory where you installed WinView.
name to one that is more specific or you can keep the default name "Camera1".
When you have finished, click on the Done button.
Figure 59. RSConfig dialog box
the Hardware Wizard.
button, click on Next and continue through the Wizard. After the Wizard is
finished, the Controller/Camera tab page will be displayed with the Use
PVCAM checkbox selected. You should now be able to set up experiments and
acquire data.
Version 1.B