Software Installation; Figure 8. Winview Installation: Select Components Dialog Box - Princeton Instruments PhotonMAX System Manual

Chapter 4

Software Installation

Notes:
1. If you have multiple cameras from Roper Scientific (PI and PM brands) on the same
host computer, it may be necessary to edit the PVCAM.INI file. Refer to Chapter 7
for instructions.
2. Leave the interface cable disconnected from the camera until you have installed
WinView/32 or WinSpec/32.
The following installation is performed via the WinView/32 or WinSpec/32 software
installation CD.
1. On the Select Components
dialog box (see Figure 8), click
on the AUTO PCI button to
install the required drivers and
the most commonly installed
program files. Select the
Custom button if you would
like to choose among the
available program files or do
not want to install the drivers.
2. Make sure the camera is
connected to the host computer
and that the camera power
supply is turned on.
3. Reboot the computer.
4. At bootup, Windows will detect the PCI card.
If you selected AUTO PCI during the application software installation,
WinView/32 or WinSpec/32 automatically put the required driver files in the
"Windows" directories shown below. If you are prompted for the locations of
these files, refer to Table 1.
Windows Version
®
Windows 2000
®
and Windows XP
System Setup
Inf File Name/Location
pmwdm.inf (in WINNT/Inf,
for example)
Table 1. Driver Files and Locations
Figure 8. WinView Installation:
Select Components dialog box
Device Driver Name/Location
pmwdm2k.sys (in WINNT/
System32/Drivers, for example)
25