Figure 10. Controller/Camera Tab - Princeton Instruments PhotonMAX System Manual

Chapter 4
WinX Versions before 2.5.19.6: Run RSConfig.exe
1. Make sure the PhotonMAX is connected to the host computer and that it is turned on.
2. Run RSConfig from the Windows|Start|Programs|Roper Scientific menu or
from the directory where you installed WinView, WinSpec, or WinXTest.
3. When the RSConfig dialog box (Figure 12) appears, you can change the camera
name to one that is more specific or you can keep the default name "Camera1". When
you have finished, click on the Done button.
Note: If the first camera in the list is not the "PM Style (PCI)" PhotonMAX camera,
please refer to "Editing the PVCAM.INI File" on page 75 for instructions on editing
the PVCAM.INI file.
4. Open the WinX application and, from Setup|Hardware..., run the Hardware Setup
wizard.
5. When the PVCAM dialog box (Figure 13) is displayed, click in the Yes radio button,
click on Next and continue through the wizard. After the wizard is finished, the
System Setup
Select
"Frame Transfer"

Figure 10. Controller/Camera tab

page
Figure 12. RSConfig dialog box
Select
"Clear Pre-Sequence"
Figure 11. Cleans tab page
27