Insert Effect (1In1Outx8) - Korg D1600mkII Owner's Manual

Phaser
LFO (LFO Waveform) .......................TRI, SIN Selects LFO Waveform
*Speed (LFO Frequency [Hz]).........0.02...20.0 Sets the LFO speed
Manual (Manual)..................................0...100 Sets the frequency to which the effect is
*Depth (Depth) ......................................0...100 Sets the depth of LFO modulation
Reso (Resonance).......................–100...+100 Sets the resonance amount
Mix (Wet/Dry)..................... –Wet...–1:99, Dry,
Trml
(Tremolo)
LFO (LFO Waveform) ......................TRI, SIN,
Vintage, Up, Down
Shape (LFO Shape) ....................–100...+100 Determines how much the LFO wave-
*Speed (LFO Frequency [Hz]).........0.02...20.0 Sets the LFO speed
*Depth (Depth) ......................................0...100 Sets the depth of LFO modulation
Mt.Dly
(Multitap Delay)
T1Time (Tap1 Time [msec]).................0...680 Sets the Tap1 delay time
T2Time (Tap2 Time [msec]).................0...680 Sets the Tap2 delay time
T1Lvl (Tap1 Level) ...............................0...100 Sets the Tap1 output level
Fdback (Feedback)......................–100...+100 Sets the Tap2 feedback amount
HiDamp (High Damp [%]) ....................0...100 Sets the damping amount in the high
Mix (Wet/Dry)................. Dry, 1:99...99:1, Wet Sets the effect balance of the multi-tap
Reverb
(Mono Reverb)
Time (Reverb Time [sec]) ................0.1...10.0 Sets the reverberation time
HiDamp (High Damp [%]) ................ 0...100% Sets the damping amount in the high
PreDly (Pre Delay [msec]) ...................0...200 Sets the delay time of the reverb sound
EQTrim (EQ Trim) ................................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) .............–15...+15 Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]) ............–15...+15 Sets the gain of High EQ
RevBal (Reverb Balance) ..... Dry, 1:99...99:1,
Gate
Contrl (Input Reverb Mix)...... Dry, 1:99...99:1,
Polrty (Polarity) .........................................+, – Switches between non-reversed and
Thrshl (Threshold) ...............................0...100 Sets the level to which the Gate is
Attack (Attack) .....................................1...100 Sets the attack time
Relse (Release)...................................1...100 Sets the release time
The Gate of 86:MM32: Reverb-Gate is connected to the Wet
output of the reverb.
This means that the on/off switch of the Gate effect is
linked to the Reverb, and will be switched on/off in con-
junction with the Reverb.
150
applied
Sets the phaser effect balance
1:99...Wet
Selects LFO Waveform
form is changed
range
delay
range
and gate control signal
Sets the effect balance of the reverb
Wet
Sets the balance between the dry and
Wet reverb sounds of the gate control signal
reversed Gate on/off
applied

Insert Effect (1in1outx8)

These algorithms can be selected as an insert effect if
"1in1outx8" is selected for "SelectEffType."
Different insert effects can be used on each of eight channels/
tracks.
Effects MN1–MN11 are monaural type effects.
"1in1outx8" effects cannot be controlled by an expression
pedal etc.
88: MN1: OverDrive/HighGain
The parameters are the same as for ODHIG.
89: MN2: Compressor2
The parameters are the same as for Comp2.
90: MN3: Limiter
The parameters are the same as for Lmtr.
91: MN4: Gate
Polrty ([G] Polarity) ...................................+, – Switches between non-reversed and
Thrshl (Threshold) ...............................0...100 Sets the level to which the Gate is
Attack ([G] Attack) ...............................1...100 Sets the attack time
Relse (Release)...................................1...100 Sets the release time
92: MN5: Exciter2
The parameters are the same as for Excit2.
93: MN6: Parametric 4band EQ
Fc1 (Band1 Cutoff [Hz])................20Hz...1.0k Sets the center frequency of Band 1
Q1 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 1
G1 (Gain [dB]) .................................–18...+18 Sets the gain of Band 1
Fc2 (Band2 Cutoff [Hz])............300Hz...10.0k Sets the center frequency of Band 2
Q2 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 2
G2 (Gain [dB]) .................................–18...+18 Sets the gain of Band 2
Fc3 (Band3 Cutoff [Hz])............300Hz...10.0k Sets the center frequency of Band 3
Q3 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 3
G3 (Gain [dB]) .................................–18...+18 Sets the gain of Band 3
Fc4 (Band4 Cutoff [Hz])............500Hz...20.0k Sets the center frequency of Band 4
Q4 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 4
G4 (Gain [dB]) .................................–18...+18 Sets the gain of Band 4
Trim (Trim) ...........................................0...100 Sets the parametric EQ input level
94: MN7: Amp Simulator
Type (Amplifier Type) ....................... AMP1...5 Selects the type of guitar amplifier
95: MN8: Multitap Delay
The parameters are the same as for Mt.Dly.
96: MN9: Chorus/Flanger2
The parameters are the same as for ChFl2.
97: MN10: Phaser
The parameters are the same as for Phaser.
reversed Gate on/off
applied