Delta InsightPower SNMP IPv6 for UPS User Manual page 59

Q6. Unable to ping or connect to the SNMP IPv6?
Check connection by following the measures below.
1) Ensure that your workstation and the SNMP IPv6 are on the same LAN.
2) You can connect to the SNMP IPv6 only when the IP addresses of your
workstation and the SNMP IPv6 are from the same address block. Normally,
private LANs use IP Addresses from one of the following blocks:
10.0.0.0~10.255.255.255
172.16.0.0~172.31.255.255
192.168.0.0~192.168.255.255
The default IP address (192.168.1.100) for the SNMP IPv6 is on the 192.168.1.1~
192.168.1.254 block. If your workstation's IP is on a different address block, you
will not be able to connect to the SNMP IPv6. To solve this problem, you can
either:
1) Use the COM port connection to change the SNMP IPv6's IP address. Please
see 4-4 Configuring through COM port.
2) Change the workstation's IP address so that they are on the same block.
(192.168.1.0~192.168.1.255)
Q7. Unable to perform an SNMP Get operation?
Check the SNMP settings of the SNMP IPv6. Please see 5-3-2 Notification. Make
sure that the workstation's IP address is added on the NMS IP list with Read or
Read/ Write access. The community string on the PC and the SNMP IPv6 must
match.
Q8. Unable to perform an SNMP Set operation?
Check the SNMP settings of the SNMP IPv6. Please see 5-3-2 Notification. Make
sure that the workstation's IP address is added on the NMS IP list, with Read/
Write permission. The community string on the PC and the SNMP IPv6 must
match.
Q9. Unable to receive SNMP traps?
Check the SNMP Trap settings of the SNMP IPv6. Please see 5-3-2 Notification.
Make sure that the workstation's IP address is added on the Target IP list.
7
7URXEOHVKRRWLQJ
Chapter