Chapter 7 : Troubleshooting - Delta InsightPower SNMP IPv6 for UPS User Manual

Chapter 7 : Troubleshooting

Q1. How to set up a SNTP server on my workstation for the SNMP IPv6 to syn-
chronize?
To enable SNTP services in Windows XP, go to Start
Remove Programs
Services check Simple TCP/ IP Services
zation, you need to set SNTP time server addresses in Time Server. Please refer
to Chapter 4: System Configurations.
Q2. How to make sure that network connection is established between my
workstation and the SNMP IPv6?
To check connection between the SNMP IPv6 and workstation, in Windows
please launch DOS prompt mode (Start
ter). In Linux, launch Shell. Enter the following command: ping Host Name
(default: InsightPower). If the connection is correctly established, you should
be able to receive replies from the SNMP IPv6.
& ?!SLQJ 
3LQJLQJ  ZLWK  E\WHV RI GDWD
5HSO\ IURP  E\WHV  WLPH PV 77/ 
5HSO\ IURP  E\WHV  WLPH PV 77/ 
5HSO\ IURP  E\WHV  WLPH PV 77/ 
5HSO\ IURP  E\WHV  WLPH PV 77/ 
3LQJ VWDWLVWLFV IRU 
3DFNHWV 6HQW
$SSUR[LPDWH URXQG WULS WLPHV LQ PLOOLVHFRQGV
0LQLPXP
& ?!
Q3. I can access the login page, but cannot log in the InsightPower UPS Web.
Please check the IP addresses of the SNMP IPv6 and the workstation you are
trying to log in. The cause could be they are not connected to the same LAN.
In that case, launch EzSetting and change User Limitation settings to Allow
Any. Please see the following figure.
Add/ Remove Windows Components
 5HFHLYHG  /RVW
PV 0D[LPXP PV $YHUDJH
7
Chapter
Control Panel
OK. To enable time synchroni-
Run key in cmd and press En-
  ORVV 
PV
7URXEOHVKRRWLQJ
Add/
Networking