Control - Delta InsightPower SNMP IPv6 for UPS User Manual

z
Bypass Transfer Voltage
After you set a tolerance of bypass transfer voltage and confirm your setup,
the SNMP IPv6 will send the command to the UPS. If the UPS transfers to
bypass mode and the bypass voltage is out of the tolerance, output will be
turned off and critical loads will be protected.
z
Periodic Auto Test
This configuration is used to set up battery test time. After you confirm your
setup, the SNMP IPv6 will send the command to the UPS and save the setup
in the UPS. When the test time is due, the UPS will automatically perform
the battery test.
z
Output Dry Contacts
After you click Submit to confirm your setup of output dry contacts, the
SNMP IPv6 will send the command to the UPS, save the values in the UPS,
and report the current UPS's status.

Control

Go to Device Management
mands. After you click Submit, the SNMP IPv6 will send the according com-
mands to the UPS to enable relevant functions. The control items include the
following.
http://192.168.1.100/
Chapter
Control to configure relevant control com-
5
,QVLJKW3RZHU 836 :HE