Table of Contents
Advertisement
28) Remote Start Engine Run Time 10 Or 20 Minutes: Default 10 Minutes. This Feature sets the period of time that the engine will run after being remotely
started. If the engine is not stopped by transmitter or a safety circuit violation, the engine will automatically stop upon the expiration of the selected time
period.
To change the system from the default setting, follow Steps 1, 2, and 3. At Step 4, press and release the transmitter's small center button. The system
will respond with two siren chirps to indicate that the engine run time is now 20 minutes. Pressing the large upper button will return this Feature to the
10 minute setting, with the system's response being a single siren chirp.
29) Automatic Remote Engine Start: Default OFF. This Feature will automatically start the engine, but it must be activated for each use. Turning this
feature on is simply making it available for use.
To change the system from the default setting, follow Steps 1, 2, and 3. At Step 4, press and release the transmitter's large upper button. The system
will respond with a single siren chirp to indicate that this Feature is ON. Pressing thesmall center button will turn this Feature OFF, with the system's
response being two siren chirps. The Owner's Manual Page 24 describes how to activate this feature for use.
30) Gasoline Or Diesel Engine: Default Gasoline. This Feature determines the parameters of ignition and starter outputs regarding gasoline or diesel
engine operation.
To change the system from the default setting, follow Steps 1, 2, and 3. At Step 4, press and release the transmitter's small center button. The system
will respond with two siren chirps to indicate that the diesel engine mode is selected. Pressing the large upper button will return this Feature to the
gasoline setting, with the system's response being a single siren chirp.
Programming Features Using The FPM-2
The FPM-2 is "wireless" and allows the installer to instantly program all 30 features to the desired setting. Operation is very easy- preset the FPM-2's
numbered switches to desired on/off positions, place the EG-1800
FPM-2 transmits the data to the EG-1800
operation.
Step 1-
Set the operating frequency to 433MHz by setting the frequency DIP switch 1 ON and switch 2 OFF.
Step 2-
Select "Code Jumping 2" by setting the code protocol DIP switch 2 ON and switches 1 and 3 OFF.
Step 3-
Referencing the following features set list, position each of the 2 through 30 feature DIP switches to the desired setting of the like-numbered
feature. The first feature, Programmable Coded Override, must be programmed manually by using the Valet Switch and transmitter.
EG-1800
ATV
SUPPLEMENT
ATV
into Features Programming Mode, then press the FPM-2's "PROGRAM" button. The
ATV
's control module; the system responds with two siren chirps to indicate a successful features programming
Page 76
Programming Features
Advertisement
Chapters
Table of Contents
