Table of Contents
Advertisement
White port marked "Aux" - both have the same operation. It
should be noted that when arming the system with the transmit-
ter, the user has the ability to bypass the sensor, if desired. When
bypassed, the system will not respond to either a prewarn nor an
activation trigger.
BACKUP BATTERY PORT - ALL MODELS
This port allows the plug-in addition of a 9 volt alkaline battery to provide alternative power to operate the system if power to the control module is
disconnected. A built-in protection circuit will not allow the 9 volt battery to back feed voltage into the vehicle's electrical system. Please note that the Siren
Positive Terminal on the system's control module is supplied by the backup battery, so in the event of the vehicle's battery being disconnected, the electronic
siren will still operate normally. The parking lights will not flash if the system is on backup battery power, as the parking lights would quickly drain the backup
battery's power.
DOORLOCK OPERATIONS - EG-1200
ATV
The E-1200
features a port for a doorlock interface. The Red 3 pin port on the system's control module produces a negative pulse for locking the doors,
a constant 12 volt pin for the optional relay coils only, and a second negative pulse for unlocking the doors.
The doorlock interface needed will depend upon the type of power doorlocks the vehicle has. The vehicle must have existing power doorlocks. A vehicle
that does not have power doorlocks may be equipped for remote keyless entry operation by adding a model DS-2 Electric Door Lock Actuator to each of the
doors and an optional DLS and relays. Another option is the addition of an Omega Central Power Doorlock kit.
DOORLOCK OPERATIONS - EG-1400
ATV
The EG-1400
and EG-1600
unlock only the driver's door upon disarming. Then, if desired, a second
press of the transmitter button will unlock all of the doors. The Red 4 pin
port on the system's control module produces a negative pulse for locking
the doors, a constant 12 volt pin for the optional relay coils only, a first
negative pulse for driver door unlock, and a second negative pulse for
unlocking all other doors.
The doorlock interface needed will depend upon the type of power
doorlocks the vehicle has. The vehicle must have existing power door-
locks. A vehicle that does not have power doorlocks may be equipped for
remote keyless entry operation by adding a model DS-2 Electric Door Lock
Actuator to each of the doors. This, and an optional DLS or DLS-3 and
relays will allow the Excalibur Gold security system to operate the
doorlocks. Another option is the addition of an Omega Central Power
Doorlock kit.
ATV
ATV
ATV
& EG-1600
ATV
adds the ability to be configured to
White Auxiliary Sensor Ports
1. Red- Constant 12 Volt (+)
2. Black- (-) Ground While Armed
1 2 3 4
1 2 3 4
3. Blue- (-) Instant Trigger
4. Green- (-) Prewarning Trigger
1 2 3
Red 3 Pin Doorlock Output Port
1. Green- (-) Lock Pulse
2. Red- Constant 12 Volt (+)*
3. Blue- (-) Unlock Pulse
* This Circuit Is To Supply Voltage
To The Relay Coils Only (Pins 85
Or 86)
Page 24
1 2 3 4
Red 4 Pin Doorlock Output Port
1. Green- (-) Lock Pulse
2. Red- Constant 12 Volt (+)*
3. Pink- (-) Unlock Pulse (1 Press)
4. Blue- (-) Unlock Pulse (2nd Press)
* This Circuit Is To Supply Voltage
To The Relay Coils Only (Pins 85
Or 86)
Plug-In Accessories
Advertisement
Chapters
Table of Contents
