Table of Contents
Advertisement
Note: The system will respond with a long siren chirp or horn honk, confirming that it is ready to learn a transmitter code. If a code is not received or the
ignition is turned "off", the learning process will automatically terminate, which will be indicated by two siren chirps or horn honks. When the first transmitter
code is learned, all other prior codes will be erased.
3) To learn the first transmitter code, press the large transmitter button, (which will arm/disarm/panic the system), until you hear one long and one short siren
chirp or horn honk to confirm that the code was learned. The two small button's functions will automatically be learned at the same time.
4) To program the second, third or fourth transmitter codes, repeat step 3. As each transmitter is learned, the long confirmation siren chirp or horn honk will
be followed by two short chirps or honks for transmitter number two, three short chirps or honks for transmitter number three, and four short chirps or honks
for transmitter number four. An attempt to add any further transmitter codes will be ignored.
5) Turning off the ignition switch or 10 seconds of no programming will turn off the transmitter learning program, which is confirmed by two long siren chirps
or horn honks.
Whenever a transmitter is coded into the system, whether an existing one or previously unknown transmitter, the siren will chirp or the horn will honk for
two seconds every time the ignition is turned "on", for 48 hours. Additionally, the LED Status Light will flash the number of transmitters which can operate
the system for 90 seconds instead of 10 seconds.
The EG-1400
ATV
and EG-1600
The Features Programming Mode is accessed through the turning "off" of the ignition switch and properly pressing the Valet Switch. Once in Features
Programming Mode, the Valet Switch is further used to specify which of the 25 Features is to be changed, then the transmitter is used to program the selected
Feature. If two failed attempts are made to enter the Features Programming Mode, two minutes must expire before attempting again (indicated by a double
siren burst or double horn honk). To access the Features Programming Mode, follow this procedure:
Step 1 - Within 5 seconds of turning the ignition "off", momentarily press the Valet Switch 5 times. The security system will respond with sounding the siren
(or horn) for a short period).
Step 2a - The Selectable Override Code must be entered before 15 seconds expires.
Press the Valet Switch the correct number of times - the factory-set default is one press for stage #1 and no press for stage #2. If the system is
configured with the default setting, it will respond by sounding the siren for a short period, then two chirps (or one long then two short horn honks).
In this case proceed to Step 3.
Programming Features
EG-1400
ATV
have a total of 25 Features which may be programmed via the Valet Switch and the transmitter in a special procedure.
ATV
& EG-1600
Page 33
ATV
Programming Features - EG-1400
ATV
ATV
& EG-1600
Advertisement
Chapters
Table of Contents
