Omega Research & Development Excalibur Gold ATV Series Comprehensive Installer Technical Manual page 78

Step 4- Access the Features Programming Mode- within 5 seconds of turning the ignition "off", momentarily press the Valet Switch 5 times. The
ATV
EG-1800 will respond with sounding the siren (or horn) for a short period.
Step 5a- The Personal Coded Override must be entered before 15 seconds expires. Press the Valet Switch the correct number of times - the factory-set default
is one press for stage #1 and no press for stage #2. If the system is configured with the default setting, it will respond by sounding the siren for
a short period, then two chirps (or one long then two short horn honks). In this case proceed to Step 6.
Step 5b- If the system has had the Personal Coded Override custom-programmed, once stage #1 been properly entered (which can be up to nine Valet Switch
presses) the system will acknowledge the entry by sounding the siren (or horn) for a short period, then one chirp (or a short honk). You now have
8.5 seconds to initiate stage #2 of entering the Override Code. Momentarily press the Valet Switch equal to the Override Code number programmed
for stage #2. The system will acknowledge the entry by sounding the siren for a short burst and two chirps (or the horn will sound one long, then
two short honks).
Step 6- Press the FPM-2's "Program" button the Red LED will illuminate to indicate that the data is being transmitted. The system will respond with two
short siren chirps (or two short horn honks) to indicate a successful features programming session; release the "Program" button. After 10 seconds
of no programming activity expires the system will exit the Features Programming Mode, which is indicated by two long siren chirps (or two long
horn honks).
Personal Coded Override Reset & Total System Reset
ATV
The EG-1800 has a Total System Reset feature. The installer, if needed, may quickly return all of the programmable features to the factory-set default
positions. However, the initial stage of the Total System Reset returns the Personal Coded Override to the factory default setting of 1 and 0 presses of the
Valet Switch. To perform Personal Coded Override Reset and/or a Total System Reset, follow these steps:
Step 1- Locate the small round hole in the lower control module case. Two solder dots will be visible beneath this hole.
Step 2- Short the two solder dots together and hold in a shorted condition (a slotted jeweler's screwdriver works well).
Step 3- Momentarily shorting the solder dots together will result in one siren burst. The Personal Coded Override is now returned to the factory-set default
position (1 and 0 presses of the Valet Switch).
Step 4- Shorting the solder dots for several seconds will result in two siren bursts. All of the programmable features are now returned to the factory-set
default positions.
ATV
EG-1800 SUPPLEMENT
ATV
EG-1800
Page 78 Programming Features
Personal Coded Override & Total System Reset