Table of Contents
Advertisement
Please note that a Programmable Feature, the 3rd Channel Output Activates Anti-
Carjacking Feature (#21), when turned ON, will add activation of the Anti-Carjacking
Feature to the operation of the 3rd Channel Output, but only when the ignition switch is
"on". The 3rd Channel Output will operate regardless of whether the ignition switch is
"on", or "off". This output will not disarm the security system when activated.
CONNECTION: For most applications an optional relay will be required (Use the
following diagram).
To Positive Or
Negative As Needed.
To 12 Volt
Positive
Output To
Optional Device
Security
Pink Wire
System
Control
87
Unit
86 87a
85
Optional
30
Relay
Optional Relay Wiring Diagram
Page - 20
Standard And Optional Plug-In Features
Red LED Status Light:
The Red LED Status Light may be mounted in the included
combination LED Status Light and Valet Switch holder. Mount the holder in a location
where it can easily be seen by the driver, and preferably where it can be seen from outside,
as the LED Status Light provides a level of visual deterrence. After mounting the
combination holder, route the Red connector to the security system control module and insert
it into the Red port on the side of the control module. For a complete description of the LED
Status Light's operation, please see the Owner's Manual.
Valet Switch:
The Valet Switch may also be mounted in the included combination
LED Status Light and Valet Switch holder. The Valet Switch allows the operator access to
TM
Easy Valet
and Valet Override modes. The Valet Switch is also part of the programming
operations for learning transmitters and changing the 23 Programmable Features. These
operations are explained in detail in the Owner's Manual. After mounting the combination
holder, route the Blue connector to the security system control module and insert it into the
Blue port on the side of the control module.
Optional Dual Zone Sensor Port:
for an optional sensor device. This port supplies constant 12 volt, grounded output when
the system is armed, a negative instant trigger, and a negative prewarn trigger. Most Omega
Research and Development, Inc. sensors will plug directly into the alarm control module.
The security system features a plug-in port
Page - 25
Continued Next Page
Advertisement
Table of Contents
