Table of Contents
Advertisement
Quick Links
Executive Model ONE
UltiMate
Vehicle Security Alarm System
with
Model ONE Remote Control
Transmitters
Owner's Guide
This device complies with FCC Rules part 15. Operation is subject to
the following two conditions, (1) This device may not cause harmful
interference and, (2) This device must accept any interference that may
be received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modi-
fications could void the user's authority to operate the equipment.
Copyright 2002
Omega Research and Development, Inc.
www.caralarm.com
www.GPS2000online.com
Advertisement
Table of Contents
Related Manuals for Omega Research & Development UltiMate
Summary of Contents for Omega Research & Development UltiMate
- Page 1 Executive Model ONE UltiMate Vehicle Security Alarm System with Model ONE Remote Control Transmitters Owner’s Guide This device complies with FCC Rules part 15. Operation is subject to the following two conditions, (1) This device may not cause harmful interference and, (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
-
Page 2: Table Of Contents
#30 Doorlock Outputs In “Add-on” Mode: Default OFF. This Programming Remote Transmitters ......15-17 feature is for the installer’s benefit, allowing him to better interface the UltiMate with the Omega Vehicle Tracking, Control and Notification Programmable Features ..........17-27 system. -
Page 3: Introduction
UltiMate to operate it. 1975. Your system offers easy, carefree operation, and the... - Page 4 LOCK button sets the pulsed horn, and pressing the UNLOCK button sets the steady siren. "Arming" the UltiMate locks the vehicle’s doors and places the security system into a state in which the vehicle is monitored for #22 Horn Chirp Level: Default 2.
- Page 5 Active Arming: The UltiMate can always be armed with the remote transmitter, provided the ignition switch is off and the #13 Confirmation Chirps: Default ON. This feature removes the system is not in Valet Mode.
-
Page 6: The Armed System
Please note that the exact operating parameters of this feature de- fast-flashing LED Status Light. Thirty seconds after the last door pends upon the installation configuration of the UltiMate system and was closed, the horn will chirp again, and the lights will flash once your vehicle's power door lock system. - Page 7 arming, opening a door will completely cancel Automatic Rearming activate, or "trigger" the system. If the system is activated: if Last Door Arming is off, and only temporarily suspend it while the The vehicle's horn (or the UltraOne package’s optional electronic door is open if Last Door Arming is turned on.
-
Page 8: Disarming The System
#3 Automatic Rearming: Default OFF. This feature ensures that If the UNLOCK button is pressed while the system is activated, your UltiMate is always armed. It is possible, on occasion, to acci- it will disarm but not unlock the doors. If the system was activated... -
Page 9: The Valet Switch
Valet correct, the system will not disarm. Another override attempt may Mode, but with the UltiMate, the ignition can be either on or off, so be made, but two consecutive incorrect entries will cause the sys- the key is not required. -
Page 10: Easy Valet
disarmed, simply press and hold the Valet Switch for 1.2 seconds This Features Programming Checklist will greatly assist in the to enter the Valet Mode. The system will confirm it has entered programming of features. Mark each applicable box with "\" next to Valet Mode with two horn chirps, two light flashes and the LED the feature to be changed before entering Features Programming Status Light will illuminate and stay on constantly. -
Page 11: Selectable Code Override
FEATURE DEFAULT Valet Switch. This programmable feature, which is explained in detail on pages 20-21, allows you to further enhance the Selectable Coded Override 1 & 0 (see page 20) effectiveness of your security system by "hardening" its resistance Last Door Arming to being defeated. -
Page 12: Remote Panic
Many of these programmable features directly affect how doorlocks- the system will only sound the horn and flash the the UltiMate operates in daily operations, and thus are important to lights. Remote Panic can also be activated by pressing and the user as they allow for a wide range of customizing the system holding the LOCK or UNLOCK buttons. -
Page 13: Led Status Light
operate your system, and Unauthorized Transmitter Alert disarmed with unlocked doors. (UTA) warns you if transmitters have been recently programmed to operate your system. With presence of mind, this “enhanced remote Panic” operation can offer some important options in emergency situations. For Every time the ignition switch is turned on, the LED Status Light example, you can flee a secured vehicle with it attracting attention shows how many operable transmitters by flashing the number,... -
Page 14: Zone Violation
However, this output may be operated when the ignition switch is on, provided that the vehicle has a door open. The Option Output Your UltiMate system can be operated by up to four different is also operable while the system is in Valet Mode.
Need help?
Do you have a question about the UltiMate and is the answer not in the manual?
Questions and answers