Table of Contents
Advertisement
5. Internal Memory Configuration and Functions
5.3. Operation parameters setting area
5.3
Operation parameters setting area
Each location in the memory is used to save data in 16 bits, that is, one word. Each of
these bits can be utilized to set or reset parameters. If the bit is set to '1' it enables certain
functions and if it is set to '0' then it disables certain functions.
Channel enable/disable (address No.0)
1.
Temperature conversion function can be enabled or disabled for respective
channels.
2.
The conversion cycle can be reduced by disabling temperature conversion for the
channel that is not needed.
3.
If the channel to be used is not specified, all the channels are in Disable state.
4.
Data of the unused channel (data read from PLC) will be all cleared to '0'.
5.
The value specified in B4 – BF will be disregarded.
6.
Use I/O parameter window of SoftMaster for more convenient setting of these bits.
88
Resistance Temperature Detector 2MLF-RD4A User's Guide
Figure 36 – Channel enable/disable
BIT
0
Disable
1
Enable
Honeywell
Description
September 2010
R200
Advertisement
Table of Contents
Troubleshooting
