Measuring Blood Pressure - Beurer BM 54 Instructions For Use Manual

The year flashes on the display.
• Select the year using the M1/M2 memory
buttons and confirm with the START/STOP
button .
The month flashes on the display.
• Select the month using the M1/M2 memory
buttons and confirm with the START/STOP
button .
The day flashes on the display.
• Select the current day using the M1/M2
memory buttons and confirm with the
START/STOP button
• If you have set the 12h hour format, the month is
displayed before the day.
The hours flash on the display.
• Select the current hours using the M1/
M2 memory buttons and confirm with the
START/STOP button
The minutes flash on the display.
• Select the current minutes using the M1/
M2 memory buttons and confirm with the
START/STOP button
The Bluetooth symbol flashes on the display.
®
• Use the M1/M2 memory buttons to select whether auto-
matic Bluetooth data transfer is activated (Bluetooth
®
symbol flashes) or deactivated (Bluetooth
shown) and confirm with the START/STOP button
Bluetooth transfers will reduce the battery life.
®
.
.
.
symbol is not
®

5. Measuring blood pressure

Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right arm.
Attaching the cuff
Place the cuff onto the bare upper arm.
The circulation of the arm must not be
hindered by tight clothing or similar.
The cuff must be placed on the upper
arm so that the bottom edge is posi-
tioned 2 – 3 cm above the elbow and
over the artery. The line should point to
the centre of the palm.
Now tighten the free end of the cuff, but
make sure that it is not too tight around
the arm and close the hook-and-loop
fastener. The cuff should be fastened so
that two fingers fit under the cuff.
Now insert the cuff line into the connec-
tion for the cuff connector.
This cuff is suitable for you if the index
®
mark ( ) is within the OK range after
fitting the cuff on the upper arm.
.
24