Table of Contents
Advertisement
English
• Once power returns after a power interruption, the pump goes back into operation with
different start-up times, depending on the setting chosen. See chapter 10.2 for the
restart times.
• SSM: Faults always result in the activation of the collective fault signal ("SSM" via a relay).
The contact of the collective fault signal (potential-free normally closed contact) can be
connected to a building automation system. The internal contact is closed if the pump is
without power, if there is no fault or if there is a malfunction of the control module. The
performance of the SSM is described in chapters 7.2.2 and 10.1.
7 Installation and electrical connection
DANGER! Risk of fatal injury!
Incorrect installation and improper electrical connections can be life-threatening.
Danger from electrical current must be eliminated.
• The installation and electrical connection may only be carried out by qualified person-
nel in accordance with the applicable regulations!
• Adhere to regulations for accident prevention!
• Comply with the regulations of the local energy supply company!
CAUTION! Risk of property damage!
Excessive force on the control module of the pump is to be avoided.
• The mains and control cable of the Yonos ECO BMS series can only be connected at the
factory. Subsequent installation is not possible.
• Never pull on the pump cable!
• Do not kink the cable!
• Do not place any objects on the cable!
7.1
Installation
WARNING! Risk of injury!
Incorrect installation can result in personal injury.
• There is a crushing hazard!
• There is a risk of injury due to sharp edges/burrs. Wear appropriate protective clothing
(e.g. safety gloves)!
• There is a risk of injury hazard due to the pump/motor falling!
Use suitable lifting gear to secure the pump/motor against falling!
CAUTION! Risk of property damage!
Incorrect installation can result in property damage.
• Only use qualified personnel for installation work!
• Observe national and regional regulations!
• When the pump needs to be transported, it may be carried only by the motor/pump
housing.
Never by the control module or preinstalled cable!
• Installation within a building:
Install the pump in a dry, well-ventilated room. Ambient temperatures below -10°C are
not permitted.
• Installation outside a building (outdoor installation):
• Install the pump in a chamber (e.g. light well, ring chamber) with a cover or in a cabinet/
housing as weather protection.
• Avoid exposure of the pump to direct sunlight.
• Protect the pump against rain.
28
WILO SE 05/2017
Advertisement
Table of Contents
