Table of Contents
Advertisement
Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
Spindle Assembly
A
B
C
Figure 1. Spindle components.
A. Spindle Motor: 3 HP motor capable of rotat-
ing cutting tool at 24,000 RPM.
B. Spindle: Motor shaft that holds the cutting
tool, spindle nut, and collet.
C. ER20 Collet: Holds cutting tool with up to
diameter shank.
D. Spindle Nut: Secures collet and cutting tool
on spindle.
-4-
manual
BEFORE
D
⁄
1
4
Power Controls
E
Figure 2. Power buttons.
E. ON Button: Enables power to machine.
F.
E-STOP Button: Disables power to machine.
To reset, twist button clockwise until it pops
out.
Additional Components
Figure 3. Oiler components.
G. Oiler System: Holds one quart of T27914
ISO-68 machine oil. One pump lubricates ball
screws and bearings on all axes.
"
H
Figure 4. Coolant pump.
H. Cooling Pump: Cools spindle motor by con-
tinuously pumping water while plugged in.
F
Model G0894 (Mfd. Since 05/19)
G
Advertisement
Table of Contents
