Test Run - Grizzly G0894 Owner's Manual

24" x 36" cnc router
Table of Contents

Advertisement

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following: 1)
the spindle motor powers up and runs correctly,
2) the axes motors run correctly and the machine
properly homes, and 3) the E-STOP button safety
feature functions properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
Clear all setup tools away from machine.
2.
Ensure controller and cooling pump are con-
nected to machine.
3.
Press E-STOP button.
4.
Connect machine to power by inserting power
cord plug into a matching receptacle.
Model G0894 (Mfd. Since 05/19)
5.
Twist E-STOP button clockwise until it springs
out (see Figure 18). This resets the switch so
the machine can start.
Figure 18. Resetting the E-STOP button.
6.
Press ON button on machine to turn machine
ON.
7.
Verify machine parameters as shown on
Page 22.
8.
Press ON/OFF button on controller to start
spindle motor. Verify spindle starts and runs
smoothly without any unusual problems or
noises. Press ON/OFF to stop spindle motor.
9.
Press HOME button on controller. Verify that
each axis motor operates smoothly and that
all axes move to machine zero.
10. Press E-STOP button on machine to turn
machine OFF.
11. WITHOUT resetting E-STOP button, try to
start machine by pressing the ON button. The
machine should not start.
— If the machine does not start, the safety
feature of the E-STOP button is working
correctly. Congratulations! The Test Run
is complete.
— If the machine does start, immediately turn
it OFF and disconnect power. The safety
feature of the E-STOP button is NOT
working properly and must be replaced
before further using the machine.
-21-

Advertisement

Table of Contents
loading

Table of Contents