Controls & Components - Grizzly G0510ZW Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to Figures 1–3 and the following descrip-
tions to become familiar with the basic controls
and components of this machine. Understanding
these items and how they work will help you
understand the rest of the manual and stay safe
when operating this machine.
Work Area Controls
Cutterhead
Guard
Fence
Figure 1. Work area components.
Cutterhead Guard: Adjusts to protect user from
chips thrown by cutterhead and allows for a clear
view of the workpiece cutting area.
Fence: Each fence is independently adjustable
side-to-side, front to back, removable for freehand
shaping, and made of wood for tighter tolerances
with cutterhead.
Miter Gauge: Supports workpiece for controlled
straight or angled cuts as it slides along the work
table miter slot.
Forward/Reverse (FOR/REV) Switch: Changes
spindle direction for specific work applications.
Switch is located on motor junction box.
-4-
manual BEFORE
Miter Gauge
Fence Offset
Lock Lever
Fence Offset
Knob Support Arm
Figure 2. Work area components.
Fence Offset Knob: Adjusts fence alignment.
Fence Offset Lock Lever: Locks fence align-
ment setting.
Fence Pivot Knobs: Tighten to lock fence posi-
tion on table. Loosen to allow entire fence assem-
bly to pivot around cutterhead opening.
Starting Pin
Location
(1 of 2)
ON/OFF
Buttons
Spindle
Elevation
Lever
Figure 3. Work area components.
Starting Pin (not shown): Supports workpiece
during beginning of freehand cuts until workpiece
contacts rub collar (refer to Page 23).
Spindle Elevation Lock: Locks spindle and bit
height adjustments.
Spindle Elevation Lever: Raises and lowers cut-
ter to desired height.
ON/OFF Buttons: Turn machine ON and OFF.
Model G0510ZW (Mfd. Since 9/16)
Fence
Pivot Knob
(1 of 2)
Guard
Spindle
Elevation
Lock