Accessory Use - Maxi-Cosi MAGELLAN Manual

Accessory Use

3
Harness Covers
Harness covers help provide comfort to the
neck. If the harness covers will not allow proper
positioning of the chest clip or interfere with getting a tight enough
harness fi t for a smaller baby, remove and do not use.
Store until your child is large enough to use these harness covers
while maintaining a properly fi tting harness.
To remove harness covers, pull the fastening strips apart and pull
them off of the harness strap.
Buckle Cover
To remove buckle cover, slide the ends out
of the buckle strap slot in pad. Pull up and off of
the buckle.
To install buckle cover, slide buckle cover over buckle and tuck
ends of buckle cover into buckle strap slot in pad.
For Use in Rear-Facing
or Forward-Facing Mode
Head and Back Pillow
The head and back pillow must be used
together.
To remove head pillow, pull it out from
behind the back pillow.
To remove back pillow, loosen the harness
straps and slide pillow out from behind the
harness straps.
Only For Use in Rear-Facing Mode
Small Infant Positioning Pillow
When used, the small infant positioning
pillow must be used with the back pillow
as shown.
This pillow helps position your infant in the
seat in order to achieve proper harness fi t.
To determine if the pillow is needed:
1. Place headrest in lowest position.
Back Pillow
Side View 2. Place infant in car seat without the pillow.
3. Make sure the infant's bottom and back
are fl at against the car seat.
Use Pillow if
Shoulder Harness
Slots are Above
Shoulders
Check often to see how much your infant has grown. Remove the
infant pillow once they can sit in the car seat without the infant
pillow and the harness slots are at or below their shoulders AND
you can still achieve a snug harness fi t.
To learn how to check harness tightness, see pages 54-56.
Only For Use in Rear-Facing Mode
Removable Cupholders
The cupholders are top-rack dishwasher
safe.
To remove cupholder, twist the cupholder
counterclockwise. Pull it out of slot in shell.
To install cupholder, align tabs on bottom of
cupholder with slots in shell. Twist clockwise
to lock in place.
4
Do Not Use
Pillow if Shoulder
Harness Slots are
At or Below
Shoulders