Maxi-Cosi MAGELLAN Manual page 29

51
10
11
NOTE: If your vehicle seat
has a headrest that inter-
feres with achieving a fl ush
car seat fi t, check your vehicle
owner's manual to see if it can
be removed, adjusted, or if
there are other possible seating
locations.
Loosely Attach Tether
Hook to Vehicle's
Tether Anchor
Check your vehicle owner's
manual for specifi c tether
anchor locations.
Attach Lower Anchor/
UAS Connector to
Vehicle's Lower/UAS
Anchor
Review your vehicle owner's
manual for lower/UAS anchor
locations and lower anchor/
UAS belt use.
Make sure arrows on
connectors are facing up.
Fasten one lower anchor/UAS
belt connector to the anchor
located in the vehicle seat
bight.
Repeat for other side of
child restraint.
12
Tighten Belt
Place hand in child restraint. Firmly push child restraint down
while pulling the free end of the belt parallel with the belt path
through the belt path opening as shown.
13
14
If it moves more than 2.5 cm (1 in.), you can try:
A. Putting your knee in the car seat and pulling the belt tighter.
B. Reinstalling the child restraint.
C. Changing to a different seating location.
D. Switching to vehicle belt installation.
52
Tighten Tether
Push fi rmly on the back of
the seat and pull the tether
strap to remove all slack and
create tension on the strap.
Check Belt Tightness
Hold child restraint at the belt
path with your weaker hand.
Push and pull from side to
side. It should not move more
than 2.5 cm (1 in.).
continued on next page