Exhaust system deltaSchwank [roof terminal]
with downstream heat exchanger tetraSchwank in room air operation and with outside
air intake in fresh air operation
- version stainless steel -
Install stainless steel flexible pipe
without sink.
Join parts of the roof terminal strongly
together by compression and using
of jointing and sealing paste
[e.g. Ceramax]!
All joints inside the building tighten
securely with clamp fittings!
tetraSchwank heat exchanger should be
mounted with slight slope [3 mm /1 m] to
the T-piece.
Fig 12: Installation tetraSchwank in room air operation, with roof
terminal stainless steel
Installation tetraSchwank _TA _Frischluft_4817
Fig 13: Installation tetraSchwank with outside air intake in fresh air operation, with roof terminal stainless steel
infraSchwank D / calorSchwank D shape U
Please note the safety distance to
flammable materials:
-single-wall exhaust pipe: 80 mm
-double-wall exhaust pipe
+ roof terminal: 0 mm
System certification tube heater
infraSchwank D/ calorSchwank D with
exhaust line system
Future ew CE 0432-CPR-00055-209
The roof terminal is fastened with
screws by means of the integrated
flange plate on the building ceiling.
The flange plate supports and secures
the roof terminal.
Installations exhaust system with heat recovery:
1. flue gas heat exchanger tetraSchwank
- pre-assembled
L= 4700 mm Article no. 62000020
2. ventilator tetraSchwank with protection grating
3. T-piece stainless steel with condensation outlet
connection R ½"
4. fastening clamp for suspension, premounted
5. single-wall roof terminal with in room air
operation Article no. 12201941
double wall roof terminal with outside air intake
in fresh air operation Article no. 62000090
15