Operation - Kemppi MasterTig 235ACDC GM Operating Manual

3. OPERATION

Before using the equipment, ensure that all the necessary installation actions have been completed according to
your equipment setup.
Welding is forbidden in places where there is an immediate fire or explosion hazard!
Welding fumes may cause injury, take care of sufficient ventilation during welding!
Check that there is enough space for cooling air circulation in the machine vicinity.
If the welding equipment is left unused for a longer period, disconnect the mains plug from the mains.
Do not use the mains plug as a power ON/OFF switch.
Always check before use that interconnecting cable, shielding gas hose, earth return cable/clamp and mains cable are
in serviceable condition. Ensure that the connectors are correctly fastened. Loose connectors can impair welding per-
formance and damage connectors.
For technical data and general guidance for selecting initial TIG welding parameters, refer to "TIG guide tables" on
page 66.
For troubleshooting, refer to "Troubleshooting" on page 56.
Tip: There is a small locker inside the power source handle, under the lid, that can be used for storing small
consumables. The device QR code can also be found here.
© Kemppi
MasterTig 235ACDC, 325DC, 335ACDC
25/77
Operating manual - EN
1920900 / 1939