ABB Wireless Proximity Switches Planning And Installation Manuallines page 32

Planning and
Installation Guidelines
Technical Description
Procedure Display content *)
SET-MAIN menue
SET
/\ or \/
SET DEFAULTS
OK, /\ or \/
SET
OK
Change CELL ID?
SET
OK
Change FB Addr?
SET
OK
Delete Config?
SET DEFAULTS
OK
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display
32 Planning and Installation Guidelines
Reset all parameters of the input module to factory settings
With this menu option the input module is set back to the factory settings:
•
Field bus address:
•
Cell-ID range identification: 1
•
Password:
•
No configuration
Operator
options
/\ or \/
ESC
OK
/\ or \/
ESC
OK
ESC
OK
ESC
OK
ESC
OK
/\ or \/
ESC
OK
000
000
Description
Change to another mode except RUN
Change to RUN mode
Change to system settings
Change to other systen setting in the SET-mode
Change to SET-MAIN menue
Change for resetting to factory settings
This display only occurs, if the actual Cell-ID – range
identifier is not equal to "1"
Change to SET-MAIN menue
Confirmation
This display only occurs, if the actual field bus
address is not equal to
Change to SET-MAIN menue
Confirmation
Change to SET-MAIN menue
Change for resetting to factory settings
Communication modules with the same Cell ID are
not deleted (and maybe partly automatically configured
again, if configuration of further communication modules
with this Cell ID is done afterwards!)
- > communication modules should be always deleted
over the DEL-Menue or directly at the communication
module!
Change to other systen setting in the SET-mode
Change to SET-MAIN menue
Change for resetting to factory settings
Wireless Proximity Switches / Issue: 09.2004
"0"
V 6