ABB Wireless Proximity Switches Planning And Installation Manuallines page 31

Planning and
Installation Guidelines
V 6 Technical Description
Procedure Display content *)
SET-MAIN menue
SET
/\ or \/
PASSWORD
OK, /\ or \/
PASSWORD
OK
123
PASSWORD
OK
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display
Wireless Proximity Switches / Issue: 09.2004
Setting of a password for the input module
For each input module a password can be set between 001 and 999, in order to prevent the
change of system settings and system parameters by unauthorized persons.
If the password "000" is chosen in the following dialogue, then the system is not protected
by a password.
Operator
options
/\ or \/
ESC
OK
/\ or \/
ESC
OK
/\ or \/
ESC
OK
/\ or \/
ESC
OK
Description
Change to another mode except RUN
Change to RUN mode
Change to system settings
Change to another systen setting in the SET-mode
Change to SET-MAIN menue
Change for editing of the password
Increase or decrease of the chosen number (blinks);
range from 000 ... 999
000: No password set (unprotected!)
Leave editing mode
Change to the next number ;
Confirmation of the password after the last number
Change to another systen setting in the SET-mode
Change to SET-MAIN menue
Change for editing of the Cell-ID
Planning and Installation Guidelines 31