ABB Wireless Proximity Switches Planning And Installation Manuallines page 30

Planning and
Installation Guidelines
Technical Description
Procedure Display content *)
SET-MAIN menue
SET
/\ or \/
CELL ID
OK, /\ or \/
12
CELL ID
OK, /\ or \/
32
CELL ID
OK
Change CELL ID?
CELL ID
OK
32
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display
30 Planning and Installation Guidelines
Setting of the Cell-ID range identification for the input module
During comissioning, each input module needs an individual Cell-ID range identification
between 1 and 60. This Cell-ID range identification guarantees that also in large installations
with more than 120 wireless proximity switches (i.e. also more than one input module) the
proximity switches communicate reliably with their assigned input module.
In the case of repeated use of a Cell-ID range identification (i.e. already more than 60 input
modules are installed) the distance, between proximity switches and the pair of antennas of
the not assigned input module with the same Cell-ID - range identification, should amount to
at least 50 m.
Operator
options
/\ or \/
ESC
OK
/\ or \/
ESC
OK
/\ or \/
ESC
OK
ESC
OK
/\ or \/
ESC
OK
Description
Change to another mode except RUN
Change to RUN mode
Change to system settings
Change to another systen setting in the SET-mode
Change to SET-MAIN menue
Change for editing of the Cell-ID range identification
Increase or decrease of the chosen number (blinks);
range from 01 ... 60
Leave editing mode
Change to the next number ;
Confirmation of the Cell-ID after the last number
Leave edit mode
Confirmation of the Cell-ID and leave edit mode
Change to another systen setting in the SET-mode
Change to SET-MAIN menue
Change for editing of the Cell-ID
Wireless Proximity Switches / Issue: 09.2004
V 6