Cfg Mode; Configuration Of Wireless Proximity Switches - ABB Wireless Proximity Switches Planning And Installation Manuallines

Planning and
Installation Guidelines
Technical Description

3.6 CFG Mode

Procedure Display content *)
CFG-MAIN menue for the configuration of further wireless proximity switches
CFG
ESC and OK
CFG-CONFIGURATION menue; display of the lowest not configured sensor number
CFG
017
CFG-CONFIGURATION (manually) for manual configuring of the selected sensor number (blinks):
The unconfigured sensor, whose membrane switch is pressed, receives this number.
Subsequently, the display of the input module changes to the next free sensor number.
CFG
OK
017
CFG
OK
018
CFG-CONFIGURATION (manually) input modul fully occupied
CFG
OK
CONFIG COMPLETE
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display
26 Planning and Installation Guidelines

Configuration of wireless proximity switches

By simultaneousles pressing ESC and OK, one changes from the RUN mode into the CFG mode.
As long as less than 120 wireless proximity switches are configured in the input module, in this
mode of operation further sensors can be added to the existing system.
The CFG mode is left by ESC or terminated automatically by the input module, if none of its four
keys has been operated within 5 minutes. In all submenues the input module changes after 30
seconds without manipulation of a key into the mode, which is reached also by ESC.
Operator
options
/\ or \/
ESC
OK
/\ or \/
12
ESC
OK
ESC
12
ESC
12
/\ or \/
ESC
Description
Selection of a mode other than RUN
Change to RUN mode
Change to CFG-CONFIGURATION menue
Change to another free sensor number or to
CFG-AUTO-DETECT menue
Change to CFG-MAIN menue
Change to CFG-CONFIGURATION menue (manually)
Change to CFG-CONFIGURATION
Change to CFG-CONFIGURATION
Change to CFG-AUTO-DETECT menue
Change to CFG-MAIN menue
Wireless Proximity Switches / Issue: 09.2004
V 6