Password Inquiry - ABB Wireless Proximity Switches Planning And Installation Manuallines

Planning and
Installation Guidelines
V 6 Technical Description
Procedure Display content *)
RUN
OK
017
RUN
Press
017
membrane switch
at communication
module

3.5 Password inquiry

If a password (001... 999) had been assigned to the input module, then this is queried after each
change out of the RUN-mode, before the first change of the settings of the input module can be
done. After 30 seconds without input, the password inquiry will be left automatically.
Procedure Display content *)
Password Enquiry
PASSWORD CHECK
Input
000
After successful password entry, the module releases the desired menu.
If a wrong number is entered, the password inquiry is repeated.
*) All sensor information and cell-ID identifications are examples; XXX stands for blinking display
Wireless Proximity Switches / Issue: 09.2004
WINK Mode
For the clear allocation of the sensor number indicated in the display to one in the field installed
wireless proximity switch the WINK-mode exists.
As long as a sensor without disturbance is displayed, this sensor can be triggered by pressing
OK so that its green LED blinks. At the same time the sensor number in the display of the input
module blinks.
The WINK-mode ends automatically after 60 seconds or as soon as it is started for another
proximity switch. Likewise the WINK-mode can be triggered by pressing of the membrane switch
on a wireless proximity switch.
1 12
1 12
Operator
options
/\ or \/
ESC
OK
Communication module (Top view)
Description
Increase or decrease of the selected number (blinkt)
leave the password inquiry
change to the next number;
Confirmation of password after the last number
Planning and Installation Guidelines 25