Table of Contents
Advertisement
Appendix A: Integration and Usage Tips
This section provides a list of useful information that is unique to the Intel
Product Family and should be kept in mind while configuring your server system.
When adding or removing components or peripherals from the server board, you must remove the AC
power cord. With AC power plugged into the server board, 5-V standby is still present even though the
server board is powered off.
This server board supports the Intel
Design Power (TDP) of up to and including 80 Watts. Previous generation Intel
not supported.
On the back edge of the server board are EIGHT (2 rows of 4) diagnostic LEDs that display a sequence
of POST codes during the boot process. If the server board hangs during POST, the LEDs display the
last POST event run before the hang.
Only ECC Unbuffered DDR4 DIMMs (UDIMMs) are supported on this Product Family.
Clear CMOS with the AC power cord plugged in. Removing AC power before performing the CMOS
Clear operation causes the system to automatically power up and immediately power down after the
CMOS Clear procedure is followed and AC power is re-applied. If this happens, remove the AC power
cord, wait 30 seconds, and then re-connect the AC power cord. Power up the system and proceed to
the <F2> BIOS Setup Utility to reset the desired settings.
Normal BMC functionality is disabled with the Force BMC Update jumper set to the "enabled" position
(pins 2-3). You should never run the server with the Force BMC Update jumper set in this position and
should only use the jumper in this position when the standard firmware update process fails. This
jumper must remain in the default (disabled) position (pins 1-2) when the server is running normally.
Make sure the recovery jumper is placed on pins 1-2, before a normal BIOS update procedure.
61
Intel® Server System R1000SPO Product Family TPS
®
Xeon
®
®
Processor E3-1200 V5 product family with a Thermal
Server System R1000SPO
®
Xeon
®
processors are
Advertisement
Table of Contents
