Samson TROVIS 5724-8 Mounting And Operating Instructions page 27

Table 4: Communication parameters
C P menu Designation
U n Communication unit
P r Communication protocol
The following values are automatically set with
the 'A P' setting: b d = 96, S t = I n
A d Modbus address
(station address)
b d Baud rate
S t Stop and parity bits
t I Timeout
Fig. 6: Bus connecting cable with 3-pin round connector (order no. 1380-2689)
EB 5724-8 EN
Setting
o F Bluetooth module not active
b L Bluetooth module active
r 4 RS-485 module active
S P SSP
o d Modbus-RTU slave
A P Automatic protocol detection
01 to .99 01 to 99
00. to 99. 100 to 199
0.0. to 4.7. 200 to 247
I 2 1200
24 2400
48 4800
96 9600
I 9 19200
38 38400
I n 1 stop bit, no parity
I E 1 stop bit, even parity
I o 1 stop bit, odd parity
2 n 2 stop bits, no parity
0 to 99 With t = 0 min, timeout is deactivated.
After the adjusted time has elapsed, the
electric actuator returns to closed-loop oper-
ation. Serves as bus failure monitoring.
White
Brown
Green
Yellow
Black
Mounting and start-up
A (incoming)
B (incoming)
A' (continuing)
B' (continuing)
Screen
27